Skip to main content

Zones

Zones allow you to define a specific area of the frame and apply additional filters for object types so you can determine whether or not an object is within a particular area. Presence in a zone is evaluated based on the bottom center of the bounding box for the object. It does not matter how much of the bounding box overlaps with the zone.

For example, the cat in this image is currently in Zone 1, but not Zone 2. bottom center

Zones cannot have the same name as a camera. If desired, a single zone can include multiple cameras if you have multiple cameras covering the same area by configuring zones with the same name for each camera.

During testing, enable the Zones option for the debug feed so you can adjust as needed. The zone line will increase in thickness when any object enters the zone.

To create a zone, follow the steps for a "Motion mask", but use the section of the web UI for creating a zone instead.

Restricting events to specific zones​

Often you will only want events to be created when an object enters areas of interest. This is done using zones along with setting required_zones. Let's say you only want to be notified when an object enters your entire_yard zone, the config would be:

camera:
  record:
    events:
      required_zones:
        - entire_yard
  snapshots:
    required_zones:
      - entire_yard
  zones:
    entire_yard:
      coordinates: ...

Restricting zones to specific objects​

Sometimes you want to limit a zone to specific object types to have more granular control of when events/snapshots are saved. The following example will limit one zone to person objects and the other to cars.

camera:
  record:
    events:
      required_zones:
        - entire_yard
        - front_yard_street
  snapshots:
    required_zones:
      - entire_yard
      - front_yard_street
  zones:
    entire_yard:
      coordinates: ... (everywhere you want a person)
      objects:
        - person
    front_yard_street:
      coordinates: ... (just the street)
      objects:
        - car

Only car objects can trigger the front_yard_street zone and only person can trigger the entire_yard. You will get events for person objects that enter anywhere in the yard, and events for cars only if they enter the street.

Zone Inertia​

Sometimes an objects bounding box may be slightly incorrect and the bottom center of the bounding box is inside the zone while the object is not actually in the zone. Zone inertia helps guard against this by requiring an object's bounding box to be within the zone for multiple consecutive frames. This value can be configured:

camera:
  zones:
    front_yard:
      inertia: 3
      objects:
        - person

There may also be cases where you expect an object to quickly enter and exit a zone, like when a car is pulling into the driveway, and you may want to have the object be considered present in the zone immediately:

camera:
  zones:
    driveway_entrance:
      inertia: 1
      objects:
        - car